
GearKo Drive Technology Limited supplies GM Series hollow rotary platforms for fixture indexing, turntable positioning, and rotary stations in automated equipment. The central through-bore provides a route for cables, pneumatic tubing, or other components. Available clearance depends on the model, connector dimensions, and installation.
GMN platforms use crossed roller bearings to support the output table. Servo and stepper motor interfaces are available depending on the model. For GMNZ right-angle configurations, check the total reduction ratio, mounting dimensions, and allowable loads for the complete drive assembly.
Selection and drawing requests
● Provide the dimensions, weights, and layout of the turntable, fixtures, and workpieces.
● Include the indexing angle, move and dwell times, start-stop frequency, and mounting orientation.
● Specify positioning requirements, the full motor model, the mounting drawing, and the required bore diameter.
Compare allowable torque, axial load, positioning accuracy, and repeatability for each model. Where table speed is rated for intermittent duty, check the rating against the intended operating cycle.
GearKo is based at 3F., No. 23, Ln. 72, Sec. 2, Changxing Rd., Luzhu Dist., Taoyuan City 338020, Taiwan. For GM Series selection, drawings, or quotations, call +886 3 324 0039 or email info@gearko-tw.com.
This site uses cookies to improve your browsing experience. we’ll assume you’re OK to continue. If you want to read more about this, please click PRIVACY, thank you.